DESCRIPTION The S16 Hydraulic Flow Demonstrator is a free-standing accessory to the Hydraulic Bench which enables hydraulic phenomena associated with the flow of water through both open channels and closed conduits to be set up quickly, easily and visually demonstrated. Measurements taken in each configuration permit the associated flow conditions to be analysed. The flow channel of the S16 Hydraulic Flow Demonstrator is constructed using clear acrylic for visibility and is supported by a floor standing, metal frame fitted with castors for mobility. The flow channel consists of an inlet tank with overflow and flow stilling arrangement, a rectangular working section and a discharge tank. Control valves and adjustable weirs allow the flow conditions to be varied independently at the entry to and exit from the working section. The working section can be flooded to create a closed conduit or operate partially filled as an open channel. The most important feature of this equipment is the adjustable section of the bed which, together with its transition section (ramps), may be raised or lowered using an external actuator whilst the water is still flowing. This facility affords a striking demonstration of the significance of channel critical depth. It is also used to vary the cross section for demonstration of the Bernoulli equation in closed conduit flow. A removable panel in the roof of the working section allows models of typical hydraulic structures to be installed, namely; a sharp crested weir, broad crested weir (also used to create a culvert) and Ogee weir. Pitot tubes and tappings connected to a multi-tube manometer allow total and static heads to be measured and compared at three locations in the working section. The height of the Pitot tubes is adjustable allowing the velocity profile to be determined at any position between the bed and the roof of the working section. Transparent scales allow all important heights and levels to be measured throughout the working section. The S16 Hydraulic Flow Demonstrator is designed to be used in conjunction with an F1-10/F1-10-2 Hydraulics Bench, which provides a recirculating water supply and a volumetric measuring facility. The Flow Demonstrator can be used with an independent water supply of up to 1.6 litres/sec provided that water discharging from the channel can be intercepted. TECHNICAL SPECIFICATIONS Width of working section: 77mm Depth of working section: 150mm Length of working section: 1100mm Maximum operating flow rate: 1.6 litres/sec
Login 
Inquiry List
